Davide e Luigi Volpi S.p.A.
Via San Rocco, 10
–
46040 Casalromano (MN)
–
Italia
Tel. +39 0376 76009 Fax +39 0376 76408 www.volpioriginale.it
COMPANY WITH QUALITY SYSTEM
MANAGEMENT CERTIFIED BY ICIM
= ISO 9001 =
43
CHECKS AND ANOMALIES
COMPONENT
ACTION
FREQUENCY
Clamps and connectors
Check the integrity and efficiency of
the contacts
Every day
Power cable
Check that the cable is not twisted
Every day
Tines
Check the integrity and locking
Every day
ANOMALIES (455SP-L-XL)
CAUSE
SOLUTION
By pressing the
start button the
motor does not
turn on or turns
on slowly.
Damaged clamps or connectors
Replace
Damaged cables
Replace
Damaged motor
Replace
Empty battery
Replace or recharge
Low battery
Recharge
Other
Contact the service
point
ANOMALIES (555SP-L-XL-655SP-L-XL-665SP-L-XL)
CAUSE
SOLUTION
By pressing the
start button the
motor does not
turn on.
All the LEDs of the power supply are off.
Damaged clamps or connectors
Replace
Interrupted fuse
Replace
Damaged electronic power supply
Replace
LEDs are regularly ON
Damaged cables
Replace
LEDs are regularly ON
Damaged motor
Replace
ALARM red light ON
Empty battery
Replace or recharge
ALARM red light ON (single impulse)
Low battery
Recharge
ALARM red light ON (multiple impulses)
Anomaly
Contact the service
point
9.
SAFETY INSTRUCTIONS
Codes 455SP-L-XL-555SP-L-XL-655SP-L-XL-665SP-L-XL
PERSONAL SAFETY
•
For safety reasons, kids, young people below 16 years old and whoever is not familiar with the
“
Operation and Ma
intenance Manual” cannot use the mach
ine.
•
Each time you need to clear or repair the machine, be sure that the electrical circuit is disconnected.
•
Do not use the machine under rain.
•
Do not use next to electrical cables at high tension.
•
It may happen that some parts become hot during the usage.
Don’t touch.
•
Do not switch on the machine while charging the battery.
IMPORTANT NOTICE
Operations not allowed:
•
All modification to the machine are not allowed except it authorized by the manufacturer.
•
Use of not original spare parts is not permitted. In case of utilization of not original parts all forms of
warranty will end.
•
During the operation of the machine it is advisable to use protective glasses.
•
After using the machine, it is advisable to clean the engine area from dust and scraps and then put it
in a dry and clear zone, with batteries fully charged and disconnected.
VIBRATIONS AND NOISE
•
Weighted root mean square acceleration value to which the hand/arm system is subjected is 7 m/ s
2
(maximum value).
•
Equivalent continuous A - weighted sound pressure level=81 dB(A).
•
Maximum value of the C - weighted instantaneous sound pressure Lpc<130 dB(C).
