Vollrath STOELTING Flavor Burst STL-80BLD, Руководство оператора

Страница: 60 / 76

57
3. The casing assembly contains very power
magnets to attach to the side of the freezer.
Simply place the assembly in line with the
Blending Assembly with the hinged surface
downward (screws at the top). The casing
assembly should be level horizontally.
4. Remove the screw from the top of the
casing assembly.
5. Swing the casing cover open.
6. Place the 9-Tube Assembly tubes inside the
casing. Also place the Drive Motor cable
inside this casing. Pull any excess tubes
and cables to the back of the freezer,
allowing enough slack in the front to
comfortably curve around to the Blending
Assembly, but not enough to droop or hang.
7. Determine where the plastic casing will be
installed. Typically, it is installed along the
side of the freezer, at the front corner, and
just above the metal casing assembly.
Clean this area with detergent water, rinse
with warm water (108°F / 42°C), and dry
with a single service towel.
8. Hold the plastic casing in position, about 2”
above the metal casing,
with the opening
seam towards the front
. Mark on the casing
where the freezer side panel meets the cap
of the freezer. Also, mark where it meets the
bottom edge of the freezer overhang.
9. Trim the casing at the upper mark. Then,
open the casing and clip a small (¼” – ½”)
hole along the open edge where the second
mark was made. This will be an exit hole
for the draw switch extension cable.