Heavy-Duty Stainless Steel Carts Assembly Instructions
3
ATTACH THE BRACES
1. Attach the reinforcing channel by sliding the slots in the reinforcing
channel over the heads of the pins on the frames. Push down on the
reinforcing channel to lock in place.
2. Line up the holes on the front brace with the holes on the frame
assembly. Attach the brace to the assembly using two round head
screws in the lower holes. Finger tighten an acorn nuts to each
screw.
ATTACH THE HANDLE
1. Attach the handle to the rear of the frame assembly using two
2" round head screws in the lower holes. Finger tighten one acorn
nut to each screw.
ATTACH THE SHELVES
1. Turn the assembly onto its right side.
Top Shelf
2. Position the top shelf with the open side facing down. Align the shelf
with the top holes on the assembly and the top holes on the frame
assembly.
3. Starting with the left frame side. Attach the top shelf using one
2
¹⁄₂
" round head screw through the top hole of the handle.
4. Then insert one 2" round head screw through the top hole of the
front brace.
5. Repeat for the right frame side.
Middle and Bottom Shelves
6. Position the top shelf with the open side facing down, between the
frame members and above the mounting brackets.
7. Push down on the corners to lock in place.
8. Repeat the steps to install the third shelf.
Insert the square four plastic caps into the corners. Insert the two
round caps into the ends of the handle.
9. Tighten all of the hardware securely.
1
¹⁄₄
"
2"
2"
2
¹⁄₂
"
