Volkswagen Motorsport
Volkswagen Golf
GTI
TCR SEQ User Manual
Volkswagen Golf GTI TCR SEQ User Manual
Page 12
Note:
Although it is possible to uncouple completely the steering wheel from the column with the engine
running, it is not advisable (causes fault messages on the OBD).
2.3 Speed limiter (Pit limiter/Full course yellow/120 limiter)
The speed limiter system allows limiting the car speed at a preselected value. There are five possibilities: 40,
50, 60, 80 and 120 km/h. This system is recommended for the pit lane area or Full Course Yellow (FCY)
situations.
Process:
1.
Select the desired speeds for each steering wheel button before starting the car and leaving the
pits. Only the FCY and Pit limiter speeds are variable, the 120 limiter cannot be changed. The
selected speeds are shown on the display.
2.
Activate the desired speed limiter with the corresponding button. From this moment on throttle
pedal may be fully pressed and the speed will be limited.
3.
If the car speed is over the target, the engine torque may be cut. If the speed is below the target,
torque will be applied till the speed is reached.
4.
Make a short push on the selected speed limiter button on the steering wheel to deactivate the
function.
Notes:
-
The FCY speed can be selected between the following speeds: 40, 50, 60 and 80. The speed can only
be selected with the car stopped following this process: red (+30) switch ON, yellow (+15) switch
OFF, keep FCY button pushed and select the speed using the gear shift paddles. The selected speed
can be seen on the AIM MXG display.
-
The Pit limiter speed can be selected between the following speeds: 40, 50, 60 and 80. The speed
