7 / 12
Elevator
Rudder
Super Cub 500 comes with pre-installed Gyro
to help control flying easily. The switch is with 3
levels to control the Gyro. To turn on the Gyro,
switch to upper position(towards you). To turn
off the Gyro, switch to lower position(away from
you).
CAUTION:
It is strongly suggested to turn on
Gyro while flying the Super Cub 500.
Binding Instruction
Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identifier) code of a single specific transmitter. When a receiver
is bound to a transmitter, the receiver will only respond to that specific transmitter.
If you need to rebind for any reason, please follow these steps:
1.Keep the transmitter switched OFF, throttle joystick at buttom position.
NOTICE
: Keep Gyro switch at Middle or Beginner position.
NOTICE
: Keep the plane still in a calm environment for calculating the Gyro.
2.Connect the battery to the plane, then turn on the transmitter within 5 seconds.
3.The receiver LED will flash for 3-8 seconds to bind automatically.
4.After the receiver LED stop flashing, it means the binding process is done.
Follow below steps when you operate a bound plane:
1.Power on transmitter first.
2.Connect the battery to the plane.
3.The receiver LED in plane will flash and then turn to solid in several seconds.
4.Switch the Gyro control stick to Gyro assist level(MIDD or BEGINNER).
NOTICE:
Allow the airplane stay still about 3~5 seconds in a calm environment when
you first time turn on Gyro, in order to calibrate and activate the Gyro. When the Gyro
starts to react, means it is activated.
5.Turn throttle stick up to max and then down to min to arm the motor.
CAUTION
: Do
NOT
operate around people or property, otherwise it may cause serious
damage!
Receiver LED
0 - Away From You- Manual / Gyro Off (EXPERT)
1 - At the Middle - Soft Gyro Assit (MIDD)
2 - Towards You - Strong Gyro Assit (BEGINNER)
