Page 8
Processor
Series
acoustics
Operation
CHANNEL 1
continued
30Hz Hi Pass switch
Pressing this switch inserts a 30Hz, 12dB/Octave slope high pass filter into the signal
path before the EQ section. Primarily intended to remove subsonic frequencies such
as stage noise and turntable rumble.
MONO LED
Pressing the MODE switch on the rear of the Resonator lights the MONO led. This
puts the two EQ channels in series to form a single mono 6 band unit. In this mode the
BYPASS and 30Hz filter switches on Channel 2 are disabled. Channel 1 BYPASS and
30 Hz Hi Pass filter now controls the whole unit.
Your input signal should now go to Channel 1's input and the output taken from
Channel 2's output. Channel 2's input is disabled.
CHANNEL 2
Channel 2's operation is identical to channel one, except the input, BYPASS and 30 Hz
hi pass filter when used in mono mode
TECHNICAL SPECIFICATIONS
Input
:
Electronically ba4dBu XLR. -10dBu 1/4" TRS jack.
20K ohm impedance. Maximum input +20dBu
Output
:
Electronically ba4dBu XLR. -10dBu 1/4" TRS jack.
100K ohm impedance. Maximum 20dBu
Performance :
THD <0.01%, +4dBu output
Noise <-86dBu (20Hz to 20kHz)
Freq response ±1dB, 20Hz to 20kHz, EQ 'in'
Input Power :
230VAC, 50Hz, 6VA Standard IEC input
Dimensions
:
1.75" (44mm) H × 19" (482mm) W × 6.5" (165mm) D
Weight
:
Net - 2.2kg. Shipping - 2.85kg
