Page 11 of 15
Manual VENIA-6sp DDA - 2021-12 EN
Mounting the U-bracket
1. Remove the M10 countersunk screws on both sides of the co-
lumn line array.
2. Use the supplied M10 hexagon head screws (A) including pla-
stic washers to mount the U-bracket.
3.
To protect the coatings, place the plastic washers between the
hex bolt, U-bracket and the column line array.
Mounting the C-bracket
1. On the top and bottom of the column line array, remove the
two M10 countersunk screws in the rear area.
2. Use the supplied M10 hexagon head screws (B) including pla-
stic washers to mount the C-bracket.
3.
To protect the coatings, place the plastic washers between the
hex bolt, C-bracket and the column line array.
Mounting the tilting and swivelling wall brackets
1. When mounting the bracket to the wall, follow the manufactu-
rer‘s operating instructions.
2. Remove the swivel bracket on the wall bracket.
3. Use two M6 x 15 mm threaded screws and washers to fix the
swivel bracket to the two M6 threaded points (C) on the rear of
the loudspeaker.
4. Hang the swivel bracket (with mounted speaker) into the bra-
cket attached to the wall.
5. Screw parts together using the lower carriage bolt, washer and
lock nut.
6.
Adjust and fix the tilt.
Working with VENIA-6sp DDA
A
B
C