[Type here]
13 14
immediately.
b. If the Power is cut off in Power off state, it is still off when the Power is restored.
4. Auto power-off function
If the device has been running for 15 hours continuously in default state after Power on and
there is no operation, it automatically turns off; if you want to cancel this function,
press and
hold the "C Mode" button for 3 seconds
, the buzzer sends Bi sound and cancels auto
power-off function; press and hold the two buttons again, the buzzer sends Bi sound and
resumes auto power-off function
Filling water:
Please add water to the tank before turning on the cooling and humidification function. Before
adding water, first open the knob of the water tank lock, tank out the water tank and fill water into
the tank slowly (Fig. 1, 2, 3 & 4): after adding water, put the water tank into the original position,
and then re-lock the knob of the water tank lock.
Please note the water level in the rear side of the air-conditioning fan water tank (Fig. 5).
1. When filling water, please keep the water between the maximum level and the minimum level
2. Be sure to use clean tap water.
3. Tips: It is normal if the water in the tank has a slight odour or discolouration when the device is
used for the first time. It is non-toxic and does not affect your health.
Use of remote control:
1. First, open the battery cover on the rear side of the remote control and insert a 3V CR2032
battery.
To open the battery cover: First press in the direction of arrow 1 shown in the figure to detach
the buckle of the battery cover, and then remove along the direction of arrow 2
2. When using, please aim at the receiver.
4. When the battery is exhausted, pull out the battery cover in the direction shown in the figure,
and replace the battery (CR2032 3V). Please note the battery polarity and put back the
battery cover before using it.
V. Cleaning and Maintenance
Fig. 5
Water tank Locked (Fig. 1) Water tank unlocked (Fig. 2) Water tank pulled out (Fig. 3) Filling water (Fig. 4)
