[Type here]
9 10
The
operation panel of the remote control is subject to the importing country.
IV. Product Installation Method
Installation method
The product can be used directly after unpacking (without installation).
Method of use of function buttons
1. Plug in the Power, the buzzer sends a "beep" sound, and the system enters standby mode. If
there is no button operation within one minute after any light and digital tube turn on, the light and
the digital tube turn dark (33% brightness); if the button is operated, the light and the digital tube
become brighter.
2. Power on/off button:
a. In Power-on state, press this button to send a long Bi- sound, and the device turns off and
enters standby mode.
b. In the Power off state, press the Power on/off button, and all LED lights flash sequentially
clockwise in three seconds; then it enters the default working state, except the timing, sleep
and natural mode. (Note: The device enters default working state only when the power cord is
unplugged for the first time; if the device is turned off and the power cord isn't unplugged, it
will enter the last state when the Power on/off button is pressed) Below is default working
states:
- Normal mode by default after turning on, no LED display.
- Digital tube displays ambient temperature, "C" indicator turns on.
- Blade indicator is off.
- Cooling/humidification is off.
- Start at medium level, turn to level low after three seconds.
- Timer function is off, the indicator turns off.
3. Speed button
In Power on state, press the Speed button to switch among low, medium and high levels.
4. Cooling/humidify button
In Power on state, press this button to switch on/off cooling/humidification, and the
corresponding indicator displays its function
5. Timing button
a. After turning on, the timer is turned off by default, and the digital tube displays ambient
temperature; when the button is first pressed, the "H" indicator turns on, and the timer is set
to 0.5h; the time increases by 0.5h when the button is pressed every time, and the timer can
be set up to 8.0 hours; if the button is pressed again, the digital tube displays 00, and the timer
turns off; press the button again to repeat the cycle; within 2-3S after setting the time, it shows
the ambient temperature, and "C "indicator turns on
b. In timer state, the last 0.5 hour counts down, the digital tube displays remaining time (not
ambient temperature) and enters standby state after reaching specified time.
6. Mode button
In Power on state, press this button to switch the normal, natural, sleep and smart.
- Normal: running at a constant speed setting.
- Natural: running at changing wind speed; in natural wind state, LED only displays the
set level, which doesn't change with the wind speed, same as natural wind.
ON/OFF
SPEED
MODE
SWING
COOLING/HUMIDIFY
TIMING
