INSTALL ELECTRICAL
Electrical wiring must be done by a qualified person(s) in accordance with all
applicable codes and standards. This range hood must be properly grounded.
Turn off electrical power at service entrance before wiring.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard
.
INSTALL THE HOOD
Note 1 : On stainless steel hoods, carefully remove the plastic protective film
from all exterior surfaces of the hood and chimney prior to final installation.
Note 2: At least two people will be required to mount the hood.
INSTALL THE HOOD
When installing the hood, the minimum safety distances mentioned
above must be kept in mind.
To install the hood, please read the following installation notes
carefully:
1. Use a Phillips screwdriver to screw the left and right mounting
bracket bolts to the end in a counterclockwise direction, and then
retract the hanger to the middle of the machine.
2.Cabinet panel requires 20mm thick, slot size: 557x275mm.
3.Use a Phillips screwdriver to screw the left and right mounting bracket
bolts to the end in a clockwise direction, and then expand the left and
right hangers outwards, and press them against the panel at the same
time, until the body glass and the panel are tight.
9
