Vogt HE S Series, Инструкции по установке и запуску

Страница: 44 / 44

Installation & Start-up – HES Series
44
Warranty Registration / Start-Up Form
HES20, HES30, HES40
Model Number: __________________________ Serial Number: __________________________
This form must be filled out completely and signed by the customer in order to assure acceptance by Vogt.
Date of Start-Up: ___________________ Form Completed By: _____________________________________
AC Condenser Model Number: ____________________ AC Condenser Serial Number: _____________________________
Water Treatment System? Yes No Manufacturer: ____________________ Model: ________________________
Bin Manufacturer: _______________________ Model: _________________________ Bin Capacity: _______ lbs.
Distributor
Company Name: ____________________________________________ Phone: _______________________
Address: ____________________________________ City: _________________________ State: ___________ Zip: ___________
Service Company
Company Name: ____________________________________________ Phone: _______________________
Address: ____________________________________ City: _________________________ State: ___________ Zip: ___________
Customer (location of equipment)
Company Name: ____________________________________________ Phone: _______________________
Address: ____________________________________ City: _________________________ State: ___________ Zip: ___________
PRE-OPERATION CHECK
______ V _____ PH _____ HZ Power (check supply (actual) at machine)—Notice: Call Vogt if under 195 V
Crankcase heater on for 2 hours minimum, prior to start
All valves opened or closed as tagged
Water supply and drains connected properly
AC condenser cold weather temperature setting(s) Solenoid ________ Fan (HES30 & HES40 only)________
AC condenser installed above machine: Yes No Approx. _____ ft.
AC condenser properly piped—are all lines insulated (see installation and start-up instructions)?
AC condenser line length (in equivalent feet (see installation instructions)) ____________
Leak checked entire system including AC condenser and lines (if applicable)
Sufficient make-up water supply (minimum 30 PSIG) Incoming potable water temperature: _____
°
F
Make-up water float valve adjustment
Compressor oil level, i.e. 1/4 – 1/2 – 3/4: ______
Compressor amps (check at start of freeze cycle) L1 _________ L2 _________ L3 _________
Cutter motor amps __________ (Should not be over 4.1 amps cutting ice—if over, call Vogt)
Water pump amps __________ (Should not be over 5.0 amps—if over, call Vogt)
Condenser motor amps (if applicable) _________
Inside ambient _______
°
F (If temperature is below 50
°
F, call Vogt)
Bin control (s) installed properly
Bin control (s) operate properly to stop and start machine with ice on them
Average hole diameter of ice ______ Clear ice Yes No
Freezing cycle time: CYL ________ CRU ________ Harvest cycle time: CYL _______ CRU _______
First ice out: CYL ________ CRU ________ All ice out time: CYL _______ CRU _______
Instruction manual and warranty certificate left on-site Name of person left with: ______________________________
Remarks:_______________________________________________________________________________________________________
Technician Signature: ______________________________ End User Signature: _____________________________
I certify that I have performed all of the above procedures.
Tube Ice L.L.C.
1000 W. Ormsby
Louisville, KY 40210
(502) 635-3235
FAX #502-635-3024
THIS FORM MUST BE SENT TO
VOGT TO ACTIVATE WARRANTY
Vogt Order Number: _______________