VOGT ICE TUBE-ICE P-24A, Руководство по обслуживанию

Страница: 96 / 146

P24A & P34A Service Manual
SERVICING OPERATIONS
12/18/12
9-10
Cutter Assembly Removal and Installation.
1. Follow water tank removal instructions, Steps 1-9. See Figure 9-5B.
2. Remove the socket head cap screw from the center of the cutter shaft and lift out the retainer and
gasket.
3. Lift the cutter straight up and off the shaft, taking care to catch the shaft key as it is removed.
4. To install the cutter, lower it down onto the shaft, allowing the ring gear to mesh with the drive gear.
5. Rotate the cutter, aligning the shaft and hub key way and inserting the key to its full depth.
6. Install the gasket, the retainer, and the socket head cap screw and tighten to approximately 15 ft.
lb. torque.
7. Check and adjust the cutter height per “Cutter Height Adjustment” instructions.
Bearing Bracket and Cutter Disc Removal.
1. Remove the cutter assembly per instructions.
2. Match mark the bearing bracket support arms with the water tank for reassembly reference.
3. Remove the splash shield and ice deflector plate from the ice discharge opening.
4. Support the bearing bracket to keep it from falling in the tank. Loosen and remove the four cap
screws and lock washers from the ends of the bearing bracket support arms.
5. Lift the bracket and cutter disc from the tank. Be sure the support arms are match marked for
reassembly. You may have to gently drive the support arms up or down to release them from the
tank walls.
6. With the bracket and disc assembly turned upside down, remove the cotter pin from the shaft.
7. Loosen and remove the slotted hex nut, spring washer, and spacer.
8. Lift the cutter disc from the keyed shaft, being careful not to loose the shaft key.
The cutter shaft and bearings are sealed in the bearing bracket assembly. The cavity between the
bearings has been filled with a food-grade grease to prevent the presence of moisture and prolong the
life of the unit. If there is any vertical or side movement of the shaft or if the bearings feel rough or
tight when turning the shaft, the assembly should be dismantled and rebuilt. Refer to the cutter tank
assembly drawing, Figure 9-5B, for parts location and identification.
Cutter Shaft and Bearing Removal.
Note: Use only a soft mallet or other soft tool for fitting all parts into place.
1. With the bearing bracket assembly removed from the tank, press the shaft out of the housing
from the bottom up.
Note: The two top bearings may come out with the shaft along with the upper seal and excluder.
2. Turn the bracket over and press the bottom bearing out the bottom, along with the lower seal.
3. There are three spacers on the shaft which should be removed and labeled as to their location.
Remove them as they are made accessible.
4. Clean and inspect all parts for wear or damage. Discard all parts showing any indication of
damage.