-21-
GLASS REPLACEMENT PROCEDURE
1. Ensure appliance is not in operation and is thoroughly cooled.
2. Remove screw and glass clips. (See parts list and diagram.)
3. Remove glass from door frame.
4. If glass is broken, carefully remove and discard each broken piece to avoid cuts. Discard window gasket.
Replace window and gasket with original factory replacement parts.
5. Replace new gasket starting at the bottom of glass working along edges, being sure to center gasket
channel on glass.
6.
Trim to length and butt ends together.
7. Perform replacement procedure in reverse order after replacing glass and gasket.
8. When replacing glass into door, be sure not to overtighten screws and clips.
DOOR GASKET REPLACEMENT
This unit’s door uses a 1-1/8” diameter rope gasket.
PROCEDURE:
1. Ensure appliance is not in operation and is thoroughly cooled.
2. Remove old door gasket and clean channel.
3. Using an approved, high temperature gasket cement, apply a thin coat in bottom of channel.
4. Starting at hinge side of door, work gasket into channel around door unit, end butt and trim to length.
5. Close door and allow three to four hours for cement to set before firing appliance.
BLOWER MAINTENANCE
The optional blower is maintenance free other than cleaning. Lightly vacuum motor and air inlet to keep free
of dust and dirt.
CAUTION: Do not operate with cracked
or broken glass.
Warning: Replace glass only with 5mm high temperature ceramic glass of the proper size. Do not
use substitute materials such as tempered glass or double thickness window glass! Contact the stove
manufacturer for replacement glass.
Caution: Do not operate a stove that is missing door gasket material. Over firing and unsafe operating
conditions may result.
