Page 19
LED blinks 7 times
The lowest limit switch has been activated.
To prevent that the lift cables rewind in opposite direction when the lift for some reason
would pass its very lowest position (below the service position), there is a lowest limit
safety switch. When this switch is activated the lift completely blocks. None of the
buttons on the remote control will work anymore. The LED will blink 7 times.
Most possible cause:
o
The lowest limit switch has been adjusted by accident.
Solve the problem:
1. To ascend the lift and de-activate the lowest limit switch use the emergency ode.
Emergency mode:
o
Open the back of the wired remote control ( is low voltage, no danger)
o
Push STOP for 10 seconds > LED will stop blinking
o
Push the “hidden” emergency UP > lift will go up again, de-activating
the lowest limit switch
o
Close wired remote control
2. Check if the lowest limit switch is set okay, app. 3 cm above the lowest point.
3. If this keeps causing problems call your importer for the electronic lowest limit
reset procedure.
Front
Rear
EMERGENCY
– only accessible when back
cover is removed
UP
DOWN
STOP
SET
- These two buttons are accessible using a narrow
pointed object.
OVERRIDE
Lift system manual
