Vodavi STARPLUS Triad XTS, Руководство по установке

Страница: 69 / 138

CO/PBX Connections 3-35
Chapter 3 - System Installation
Installation
1. Insert the BRIB card(s) into the desired card slot. Up to seven BRIB cards can be installed in
an XTS Cabinet, with a maximum of 18 per system.
†
If installing a single BRIB, set switch 4 on SW2 to the ON position.
†
If multiple BRIB cards are being installed, set switch 4 on SW2 to the ON position on
the first card and switch 4 on SW2 on all other cards to the OFF position. Switch 4 on
SW2 determines if the board is the Master Clock source for any digital trunk cards in
the system. Only one Master Source must be enabled in the system.
†
If installing a BRIB in a system that also has T1 or PRIB boards, use either the T1 or PRIB
card as the Master Clock and set all BRIB SW2 switch 4s to OFF.
2. Refer to ISDN and T1 Clocking (later in this section) for clarification on clocking and
cabling when combining BRIB, PRIB, and T1 cards in one Cabinet.
Figure 3-20: BRIB (Basic Rate Interface Board)
Voice Over the Internet Protocol Card
The Voice Over the Internet Protocol (VOIP) card provides up to eight lines per card (two lines
per installed VOIP module). The VOIP card allows bi-directional voice communication to
other H.323 Revision 2 compatible devices via an IP network such as an internal Local Area
Network (LAN), the Internet, or a Wide Area Network (WAN) using the Ethernet Interface. It
also provides four-digit dialing.
The VoIP card uses Transmission Control Protocol/Internet Protocol (TCP/IP) for packet
delivery over an IP network. Additional standards and protocols are used to provide DTMF,
voice processing, and compression.
The VoIP card can accommodate up to four VoIP modules. Each VoIP module provides
capability for two ports, resulting in a maximum of eight ports when all four modules are
installed.
Installation
Insert the VoIP card into the desired slot.
ON
OFF
SW2 SWITCHES: 2 3 4
1