Vodavi STARPLUS Triad XTS, Руководство по установке

Страница: 121 / 138

Maintenance Access 4-19
Chapter 4 - Maintenance and Troubleshooting
Event Trace Mode
The “t” command enables and disables the Trace mode in the XTS System. While the trace mode
is enabled, events for the trace selected are displayed in an event record on the monitor,
printer, or PC connected to the
XTS System.
To view the current status of the trace mode:
1. Type t at the mon > prompt.
2. Then press <Enter> to display the following commands:
Figure 4-6: Remote Monitor - Trace Mode Status
To enable an Event Trace:
1. Type: t< space >( followed by the letter that indicates the kind of specific trace needed)
2. Type the specific board, CO line, or Station number of the trace desired,
-or-
Type all if all boards, CO line, or Station events are desired.
B = Board event trace (traces events associated with PCBs)
C = CO Line (LCOB) States (traces events associated with CO Line activity)
D = Device Command (traces commands to peripheral devices)
E = Error Messages (traces error messages)
H = Hardware States (traces events associated with hardware states)
I = CTI (traces from and to devices)
K = LCD (traces commands to devices)
L = LED (traces commands to devices)
M = Miscellaneous State event trace
P = Pulse Coded Modulation (PCM) traces events associated with voice communications
Q = Queue (QUE) Events (traces queuing events, e.g.: DTMF receiver, UCD, LCR, etc.)
S = Station (STA) States (traces events associated with Station activity)