8
Getting Connected
CONNECTING POWER
Connect the AC power adapter to the power input
jack on the far right of the back panel on the
VHF-4000 .
CONNECTING AUDIO OUTPUT
USING THE XLR OUTPUTS:
The XLR outputs allow you to connect each channel
to the mixer independently . This gives you more
control over the individual microphone channels
when connected to a mixer .
You’ll need:
• VHF-4000
• (4) XLR patch cables (not included)
• An input device, such as a mixer or amplifier (not
included)
TO CONNECT THE XLR OUTPUTS:
1 . Ensure the main power switch is turned off .
2 . Connect one end of an XLR cable to the CH .1
output of the VHF-4000 .
3 . Connect the other end of the XLR cable to the
desired input on your mixer .
Note: To avoid confusion, it’s recommended that the XLR jacks
are attached correspondingly (e.g. CH.1 to CH.1, CH.2 to CH.
2, etc. as shown).
4 . Repeat steps 2 and 3 until all the XLR outputs
are connected .
USING THE 1/4” MIXED OUTPUT:
The 1/4” mixed output is useful if you do not have
limited inputs available on your mixer . All four
microphone signals are mixed together in this
output .
You’ll need:
• VHF-4000
• (1) 1/4” patch cables (included)
• An input device, such as a mixer or amplifier (not
included) .
TO CONNECT THE 1/4” MIXED OUTPUT:
1 . Ensure the main power switch is turned off .
2 . Connect one end of a 1/4” cable to one of the
1/4” mixed outputs on the rear panel of the
VHF-4000 .
3 . Connect the other end of the 1/4” cable to the
desired input on your mixer or amplifier .
VHF-4000 Rear Panel
VHF-4000 Rear Panel
Mixer
Mixer
VHF-4000 Rear Panel
