8. +5V USB IN
- This mini-USB connection is used to
recharge the batteries, if rechargeable batteries are
installed .
Note: DO NOT ATTEMPT TO RECHARGE ALKALINE
BATTERIES;BATTERIES MAY EXPLODE.
Note: This input will NOT interface with a computer or any
other device; it will only charge the batteries if plugged into
a computer.
9. Charge Indicator
- This LED indicates the charge level
when recharging the batteries.
• If LED is green, batteries are charged.
• If LED is red, batteries are charging.
10. Battery Compartment
- This is where the two (2) AA
batteries are installed.
• Either alkaline or rechargeable batteries can be used.
Only rechargeable batteries should be used with the +5V
USB IN.
11. Clip
- This metal spring will hold the receiver in place
when attached .
CHARGE
USB IN
+5V
RF
POWER
ON
OFF
ANT.
18
BRACKETS AND MOUNTING
The Silent P.A. is packaged with a bracket kit to allow
installation into standard 19” rack mounts.
Mounting with a single Stationary Transmitter (ST):
1 . Remove the 4 phillips head screws; 2 on either side of
the ST.
2 . Attach the large and small brackets on either sides of
the ST.
3 . Secure the entire receiver into a 19” rack case with the
mounting brackets.
Note: When installed into a rack case, the antennas will
need an open back to the rack to ensure full range.
Remove
1
