7
Watch Not Receiving Time Signal
Reasons for not being able to receive the Time Signal include:
-Being outside of the USA, UK, Germany, or Japan (60Khz) signal area
-Being inside a concrete building
-Metal objects blocking the radio signal
-Interference from other electronic devices
Ensure that the watch is left by a window, as this gives the best reception, you may have
to try different windows in the house to see which is best. You can test this using the
reception status test as described earlier. Please note that reception is always better at
night. If your watch is unable to make contact with the radio signal, it will continue to
function in the same way as a standard watch. The time will then be corrected the next
time your watch receives the time signal.
Battery Change
This watch uses a CR2032 type battery
, replacement batteries should be installed by
Talking watch experts when available
( you can contact 1-800-522-6294 for our
authorized battery Replacement Service)
or use a trained jeweller or watch specialists
to replace batteries while being careful NOT to damage to internal components this watch.
1.
Open and remove the watch back carefully, making sure not to lose the
waterproof seal.
2.
Pick up the battery spring on the right.
3.
Take out the battery and insert a new one (
watch the polarity!”+”up).
4.
Now push the battery spring down.
5.
Before you put the case-back on again, make sure the waterproof seal is correctly
in place.
Now follow instructions for watch Restart Procedure below.
Please NOTE: The Watch will not operate after a new battery has been
installed until the following procedure has been performed:
Watch restart procedure (after Battery replacement):
1.
Holding S1
button until the hands move quickly. You can stop the fast movement by
pressing S1 once.
2
. Stop the hands from fast spinning before the second hand reaches the 12 0’clock
position (11:58:00) by
pressing S1.
3.
Adjust the second-hand one second at a time to move it to the 12 o’clock position
(12:00:00) by
repeatedly S1
. (If you accidentally go past the 12, start this process again.)
4
. When all hands are aligned at the 12 o’clock position (12:00:00),
PUSH S3 (the left
upper button) for 1 second to confirm.
