4
5.
After selecting the proper Country and time Zone PRESS S4 to confirm
6.
After confirming the above, the watch hands will advance (unless already correctly
set) until reaching the country and time zone you have selected. (Please do not disturb
the watch, as the hands will spin fast around the dial until the proper Country- Time
ZONE settings are reached. Please Note: this may take several minutes).
7.
Your watch will now display the time and time zone of the selected country, however
when setting watch during “Daylight Savings Time” the watch may initially display
an hour difference until it receives the signal reception update which will correct the
time.
8.
The watch will synchronize with the atomic clock within the selected country. This
will occur automatically at 3am. (Please make sure that the right country has been set
or the watch will not be able to pick up the local signal).
9.
After this process has been completed, your watch will show the local time of the
country that you have selected.
Manual Signal Reception:
You have to set the watch with the right country before performing the following
Manual Signal Reception
. Use the “
Country Signal Selection instructions”
for details.
You have to put the watch on a table nearby a window when you need a manual signal
reception. Please pay attention to the position of the watch. You must put the watch on
the table according to position shown on the picture above or the watch will not be able
to pick up signal.
While the watch is in the Real-Time (Regular) mode,
1.
Holding S3
(the Left upper button) until the second-hand stops.
2.
The watch takes about 5 to 14 minutes to pick up radio signal. Wait until the watch
has finished the signal receiving procedure.
3.
After signal reception, the watch will show the time again after the fast spinning of
the second-hand has stopped.
4.
Push S4 once
. The watch will announce the status of the reception.
-If the reception was successful, the watch will announce the “Country name”
follow by
“Time Updated”
-If the reception was failed, the watch will announce
“Country name”
follow by
“Time Not Updated”
(Go to “
Reception Status Check”
for details)
