6
Manual Time Setting:
(Use this option when you travel to countries with no radio signal. Be sure to set your watch to
your local time when you come back from countries without radio signal or your watch will be
unable be able to pick up signal at 3AM.
1.
Holding S4
while the watch is in the real-time mode for more than 5 seconds until the
watch says
“Set Alarm, Press S3 to set”
2.
Push S4 -
4
more times
, until the watch says
“Set Time, Press S3 to set”
3.
Press S3
4.
The watch states instructions
“Press S1 to set Hour, S2 for minute, S4 to confirm”
5. Press
S1
to set the Hour
. When setting the hour, listen very carefully to the watch
making sure that you select the right hour in AM or PM
(If watch is set incorrectly for AM/PM your watch will not pick up signal at 3:00AM)
5.
Press S2
to set the correct minute
6.
Press S4 to confirm
after you have set the Time
7.
After confirmation, the watch will run to the time you have set automatically. Wait
until the watch hands stops spinning fast until it resumes to run as normal
You will not be able to manually set the Date, Day, Month and Year. The watch will
set this information only when a first signal reception was updated.
TROUBLESHOOTING:
Your watch is a very delicate and precise instrument, and although uncommon,
sometimes hard knocks or vibrations can cause the hands to move irregularly. This may
cause the watch to display the incorrect time, although the internal clock is correct. You
may notice this when performing “manual signal reception” as shown above, and the
second-hand does not pause exactly at the reference point as is indicated (half second
deviation is acceptable), If this occurs then the second-hand needs to be re-calibrated.
Re-calibrate the shifted second-hand:
1.
Make sure the watch is running normally
2.
Holding S4
for more than 5 seconds until the watch says
“Set Alarm, Press S3 to set”
3.
Push S4 repeatedly
until the watch says
“Second-Hand alignment, Press S3 to set”
4.
Press S3
5.
The second-hand will spin to a new position and then stop somewhere before 6
o’clock
6.
Press S1
repeatedly until the second-hand points exactly at the
6
o’clock position
7.
Press S4
to confirm -the watch will stop for a while and then will resume running
8. After the watch resumes running, the second-hand is re-calibrated.
