G-602
7
c
、
Two outputs from G-602 will come from the same signal source. It is not for 2 independent
displays.
d
、
User needs to use Micro USB cable for PC & G-602 connection if Gwarp PC Tool is used. User
can extend USB control distance through USB extension cable.
e
、
IF GeoBox is installed in control room, please extend IR receiver to a place for easy remote
controller access. User can use audio cable as extension cable.
f
、
User can execute G-602 OSD operation through Ethernet connection. Virtual keys in WebGui
are available. Ethernet module is option. Need to be installed in factory.
g
、
Select input port and set GeoBox output resolution to be same as projector native resolution.
h
、
User needs to apply a signal source while video wall [Overlap] value setting. Signal source
resolution should be the same as Excel calculation. To apply 1080p signal is recommended.
After system setup, user can use any input resolution.
i
、
Press [INFO] hotkey to check if the final in/out timings are the same as expected.
4.3 Excel Spread sheet calculation
a
、
User needs to get below data for edge blending plan: (3x projectors as Example)
Input signal resolution: (3840*800)
Number of projector.(3 projectors)
Projector resolution and lumens. (1280*800, 3200 Lum)
Required image size (screen size: 6.5m*1.5m)
Overlap pixels and dimension. (8 grids=8*32= 256 pixels)
Projector throw ratio: 1.2-1.7
b
、
The above is the calculation result. Please contact dealer or factory to get necessary
assistance for these data.
Final image size for each projector: 2.500m*1.563m
User can use geometry alignment to draw the vertical height to the dimensions you need.
In this example, the final image height is 1.5m after geometry alignment.
Based on these data, user can make a layout plan and decide the
installation dimensions and locations.
