G-602
5
negligence. To press [OSD Lock] key or [MENU] key for 5 seconds again, it will unlock OSD and
user can manipulate the OSD again.
o.
[Image Setup] menu will not be activated if the input source is not from VGA.
p.
Please reset GeoBox before any new application to avoid unexpected settings in the system. If
deeper reset is required, user can turn on GeoBox and press both [Menu] + [Pattern] key on front
panel and power on GeoBox again for 5 seconds. It will reset the system
q.
To set [Menu Time Out] to “0”, the OSD will appear till the OSD Menu has been turned off
manually or system input timing change.
r.
Default Internal Grid Pattern represents 32x32 pixels no matter which input resolution is selected.
s.
Only HDMI-A input port can provide HDMI raw signal loop out for daisy chain connection. This
loop out signal has no any processing.
t.
When [Gwarp] PC tool is used, user needs to save the setting into GeoBox through the OSD
menu: [Anyplace]
[Gwarp Pro]
select [UserMap 1-10] to save the settings. Then PC can be
removed.
u.
When Power Off/ON GeoBox, it will maintain the final settings.
v.
User needs to save the final setting into [Profile] under [Options] menu for long tern stored inside
the system. Even the system is reset, the [Profile] settings will be kept without change.
w.
Continuously press PATTERN button, internal test pattern will show different colors for easy
installation: White
—Red—Green—Blue—Blank. When in “Blank”, user can see OSD and the
image from signal source. In this case, PC test pattern can be applied.
x.
Please use INFO hot key on front panel or remote controller to check the input and output timing.
The indicators on the front panel will show the input/output connection status.
y.
User can set black background while no input signal is detected and input timing change under
[Options]
[Accessibility] menu.
z.
Below hotkeys are available in remote controller:
[Warp] geometry alignment, [Video wall], [Edge Blend], [Info], [CH A/B] switching.
