G413 User Guide Document: G41302
-------------------------------------------------------------------------------------------------------------------------------------------
45
1)
After collect coordinates for all LCD, user can upload the coordinated into G413 though OSD.
2)
Example to store custom mode in Mode #2
[Video wall]
[Mode Index]
[Mode 2]
Select [TV1]
Select [Top Left/Top Right]
Slide
bar to input Coordinates
TV1 Done
Back to select [TV2]
Select [Top Left/Top Right]
Slide bar to input Coordinates
TV2
Done
Next step is to execute the same procedures for TV3 & TV4.
3)
User may have some difficulty to see the OSD to set Coordinates. The best way is to use
Galign2 PC tool to upload coordinates.
4)
The OSD will show on the center of video wall. User can finish the setting from center, then
extend to outside. It will reduce the trouble in not seeing OSD menu on the screen.
13.5.2 Upload coordinates via Galign2 PC tool
Procedures to key-in coordinates into G413:
1) Select manual display mode storage location—Mode1~Mode10
2) Select output port—TV1~TV4 (LCD)
3) Click Top LH to key-in Top Left X (horizontal) & Y (vertical)
coordinates. User can see the number on the OSD.
4) Click Top RH to key-in Top Right coordinates.
5) Click [F1] to do image H&V position fine-tune in each LCD.
6) Select [R] to adjust entire video wall aspect ratio if necessary
7) Select [P] to adjust entire video wall display position if necessary
Output port selection
Store location for manual setting display
modes
Video wall Main menu
Entire video wall position adjustment
To adjust image position at H&V without changing image size
Entire video wall aspect ratio adjustment
Top Right coordinate menu
Top Left coordinate menu
