VMAC
–
Vehicle Mounted Air Compressors
Toll Free:
1-888-241-2289
Fax: 1-250-740-3201
11
Pin
Pry-bar
Oil pan
Figure 3.4
□
Install the M12 bolts just finger tight (longest in the front and
shortest in the rear) and check to make sure that the bracket is
flush against the block. Once you have checked the fit, remove
the bracket.
□
Install the compressor on the bracket using the two hex head
bolts and the countersunk bolt. Use Loctite and tighten securely.
□
Ensure that the supplied 5/16” washer is installed on the hex
head bolt that is closest to the front of the compressor and
engine.
□
Apply Loctite and insert the rear M12 bolt through the bracket, lift
the compressor-bracket assembly up under the AC compressor
and angle the front of the bracket over the front of the oil pan so
that the bracket is “hung” in position.
□
Apply Loctite and insert the front M12 bolt, lift the bracket into
position and thread the bolt into the engine.
□
Thread the rear M12 bolt into the engine. Tighten both M12 bolts
then tighten the bottom AC bolts against the main bracket.
□
Apply loctite and install the M6 tensioner stop bolt (Fig 3.5).
