FCC Regulatory Compliance
Notices Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation
.
Cautions and Warnings
CAUTION:
Danger of Explosion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturers instructions.
CAUTION:
The unit should be mounted 1-2 feet away from other units. Can
be adjusted based on lane setup.
CAUTION:
The unit should not be placed directly on or within 4 inches of
any large metal surfaces.
WARNING:
Avoid close proximity to items such as cellular telephones
and portable 2-way radios which may reduce the ability of the reader.
For IC Regulatory Compliance:
"Operation is subject to the following two conditions:
(1) this device may not cause interference,and this device must accept any interference,including
interference that may casuse undersired operation of the device.
Information to user
The users manual or instruction manual for an intentional or unintentional radiator shall caution the
user that changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. In cases where the manual is provided only
in a form other than paper, such as on a computer disk or over the Internet, the information required
by this section may be included in the manual in that alternative form, provided the user can reasonably
be expected to have the capability to access information in that form.
