ViVOpay Kiosk II User Guide
631-0071-01 ViVOtech
Proprietary
Page
10 of 23
2.4 Mounting the ViVOpay Kiosk II Controller
Note:
The ViVOpay Kiosk II Controller must be mounted within 1 meter of the external antenna.
Make sure that the cable will be able to reach from the external antenna to the ViVOpay Kiosk
Controller if the external antenna is mounted of a surface that opens (such as a door) when the
antenna mounting surface is fully opened.
The ViVOpay Kiosk II installer must use their discretion when mounting the Controller.
If it acceptable, the installer can drill four holes for mounting the Controller if screw heads can
appear on the outside of the Kiosk. In this case, it would be advisable to use security screws to
prevent tampering with the screws.
If drilling additional holes on the outside of the Kiosk surface is not acceptable, the installer can use
double-sided tape to mount the Controller to any clean surface.
2.4.1 Mounting the ViVOpay Kiosk II Controller Using Screws
1. Position the ViVOpay Kiosk Controller on the interior of the II making sure that there is
sufficient room for the external antenna mounting surface to be fully opened.
63.50 [ 2.500
]
2. Locate the four 4.4mm (0.173 inch) mounting holes by holding the ViVOpay Kiosk
Controller in position and mark the holes. The following diagram shows the spacing on the
holes to be drilled for mounting the ViVOpay Kiosk II Controller.
3. Drill the four 4.4 mm (0.173) mounting holes using a number 17 drill bit.
4. Use four screws and nuts to mount the ViVOpay Kiosk Controller to the Kiosk surface.
(Mounting screws are not provided and must be supplied by the installer.)
5. Tighten the nuts to hold the ViVOpay Kiosk II Controller in position so that it does not move.
2.4.2 Mounting the ViVOpay Kiosk II Controller Using Mounting Tape
1. Position the ViVOpay Kiosk II Controller on the interior of the Kiosk making sure that there
is sufficient room for the external antenna mounting surface to be fully opened.
2. Attach double-sided tape to the mounting surface.
3. Position the ViVOpay Kiosk II Controller over the mounting tape and gently apply pressure
to hold the Controller in position.
