Multi-function AV Distribution System
26
5.4 Copy and Load Control Settings
The system IR or RS232 configuration can be copied to a USB thumb drive and loaded
into additional systems or be saved as a backup.
Copy Control Setting
1)
Insert a 4GB or smaller FAT32 formatted thumb drive into the
CONFIG
port on
the control panel.
2)
Press and hold
SOURCE
for five seconds on control panel until all buttons start
to flash.
3)
Press
DISPLAY ON/OFF
on control panel, and the button will light up while the
copy is in process.
4)
Remove the thumb drive from the
CONFIG
port once all buttons go dark.
Load Control Setting
1)
Insert a 4GB or smaller FAT32 formatted thumb drive with saved configuration
settings into the
CONFIG
port on the control panel.
2)
Press and hold
SOURCE
for five seconds on control panel until all buttons start
to flash.
3)
Press
SOURCE
on control panel, and the button will light up while the upload is
in process.
4)
Remove the thumb drive from the
CONFIG
port once all buttons go dark.
5)
Enter the Command Tab via GUI, the loaded RS232 commands will be showed,
and then press
Save
to confirm them.
