36
H9090 Home Theater Projector - User Manual
using the socket’s switch instead of the remote. If you do not need this function, please set
it to Off.
Rear Projection:
This control reverses all images and menus, and is necessary when the
projector is used in rear-projection applications. The default is Off.
Celling Mode
:
This control flips the image so the projector can be used in ceiling mounted
installations. The default setting, Auto, automatically determines the orientation using an
internal sensor.
Refer to Page 15 --- Modes of installation
Logo Display:
This feature enable and disable Vivitek brand logo during projector warming
up stage
.
OSD Introduction - CONTROL
Select Control from the Main Menu to set various options related to control of the projector.
MAIN
SERVICE
LANGUAGE
CONTROL
SYSTEM
ADVANCED
Menu = Exit
Menu Select ◄►
Scroll ▲▼
1 Key
2 Key
3 Key
4 Key
5 Key
Trigger-1
Trigger-2
Auto Source
Enter
Enter
Enter
Enter
Enter
Screen 16:9 Letterbox 4:3 4:3 Narrow RS232
Screen 16:9 Letterbox 4:3 4:3 Narrow RS232
On
Off
1 Key / 2 Key / 3 Key / 4 Key / 5 Key:
These menu items assign the function of the keys
numbered 1 through 5 on the remote
.
There are seven sources corresponding to the eight connections to the projector. When
you assign a source to a numbered key, the projector immediately goes to that source
when the key assigned to it is pressed.
If the chosen source is disabled via the Source Enable menu, this setting has no effect
Trigger 1 and 2:
Select Trigger 1 or 2 from the Control menu to specify when the Trigger 1
port outputs 12 volts. There is a three-second delay before activation to prevent operation
while selecting an aspect ratio.
•
Screen: The port to output 12 volts whenever the lamp is on.
•
16:9: Causes the port to output 12 volts whenever the 16:9 aspect ratio is chosen.
•
Letterbox: Causes the port to output 12 volts whenever the Letterbox aspect ratio is
chosen.
•
4:3: Causes the port to output 12 volts whenever the 4:3 aspect ratio is chosen.
•
4:3 Narrow: Causes the port to output 12 volts whenever the 4:3 Narrow aspect ratio is
chosen.
•
RS232: Causes the port to output 12 volts when an RS232 screen trigger 1 “on”
command is received and stop when trigger 1 “off” command is received. The 12 volt
