Vivitek DU9900Z, Руководство пользователя

Страница: 32 / 67

DU9900Z DLP Projector - User Manual
31
UM99000721EN00
Using Control ID for Multi-Projector Application
When installing more than one projector in the room, the projectors may receive the control signal at the same time. In this
case, you can use control ID function to specify the identification of the projector and remote control to operate the
specified projector. Follow the below steps to set up the identification number for the projector and remote control.
Set the Projector identification number
1. Enable Projector ID Control function from CONTROL->Infrared Remote->ID Control Enable as below figure.
The message box is displayed to confirm enabling ID control after selecting ON option, please OK button to confirm or
Cancel button to skip it.
2. Set Control ID Number
Select Control ID Number option then press Enter button, use the
► button to increase the number or the ◄ button to
decrease the number. This option is available when Projector ID Control is turned on.
Set the identification number of remote control
Press and hold ID SET button on the remote control around 5 seconds, Power LED indicator is flashing red periodically.
Press two digits to set desired ID number, each pressing shall be leisurely. Power LED will flash on time when the
remote control is confirmed the setting.
Press and Hold ID SET button
around 5 seconds Power LED is flashing Press two digits for ID number
Note:

Setting the identification number will overwrite the ID number you had set. You can set the ID number
directly if you would like to give a new ID number for the remote control.