VIVAX
ENG
8
PARTS DESCRIPTION
OPERATING
Place the heater on the floor at least 100 cm away from the wall and any other objects
such as furniture, curtains or plants.
(Make sure the power supply used corresponds to the one on the rating label)
Check weather that main power switch is in "OFF" position and then plug the heater into
the main power supply.
Place the heater on flat stable surface
Plug the heater in
START UP
Turn the power switch to "
ON
" identification location; the buzzer gives
a long "bee" sound signal. The unit enter in Standby mode, Digital
display will not display any information.
HEATING POWER SELECTION
Press the “
ON/OFF
” key to start up, the heater enters into the Normal
working mode, works with the low power of 600W.
The icons and
are brightened. Press the "
+
" or "
-
" key to enter
into the setting interface, when the setting temperature value starts
flickering, the temperature can be set by continuously pressing the "
+
"
or "
-
" key, in the range of 5 – 35°C.
If you don't press any key within 5 seconds, the panel heater will exit
from the setting interface, the set temperature value stops flickering.
Display is showing the corresponding set temperature value.
1. Air Outlet
2. Control panel
3. Buttons
4. Power switch
5. Rear cover
6. Support pad
7. Castors
8. Digital Display
9. Tempered Glass
panel
2
3
4
5
6
7
1
10
8
9
Содержание PH-1500D B
Страница 62: ...VIVAX ...
Страница 80: ...www VIVAX com ...