Page 22
Gruber Antrieb GmbH & Co KG | brixentAlerstr. 51 | 6300 WörGl | t: +43 5332 70317
10. shorT DescripTion
Battery management:
For best results please charge the battery fully the first time you use it
and take care for the loading- and storage instructions.
Charge level indicator:
When pressing the button on the battery, the current charge is indica
-
ted by 1-5 LEDs (vague guideline) and expires after 4 seconds again.
Charging
: During charging the LED on the charger will light up green; the battery is not fully
charged until you can see a continuous green light (after app. 3-6 hours – depends on the capa-
city). Never leave the battery while recharging on a flammable material or in a box (saddlebag).
Storage: Do not charge, use or store in temperatures below freezing or above 30°C. Over the
winter the LiIon battery pack should be kept charged at about 60 % (never
lower). It will need to be recharged after about 3-6 months.
Transport: Never leave the battery connected when transporting the bicycle. We recommend
storing it well packed separately – not in the saddlebag. Fire risk can happen when severe
damage occurs. Inquire before a flight by your airline.
Operating the drive:
Connect the charged battery in the saddlebag to the large black round
connection plug. The small black, 6-pin connector (push button – do not
separate or rip from the cables) must also be connected! The small 3-pin connector needs only
be joined to the speed sensor if a speed limiter (25km/h limit) has been installed.
Close the saddlebag! Only use the push button while driving – never when stopped! Quick press
(about 1 second) of the push button and the drive runs with the pre-programmed speed. Press
again and the drive switches off. The drive is not suitable for use in sub-zero temperatures.
Store the pedal frequency:
If you pedal faster than the pre-programmed speed, you overtake
the drive and it no longer has its full effect – store a higher speed or drop back (expend less of
your own energy)!
For storing the highest number of revolutions (RPM) keep the push button pressed for at least
10 seconds.
You can store your own personal frequency (RPM). Turn the required RPM with the push button
pressed for 5 seconds. After releasing the button the stored frequency is available for use.
The frequency of the pedals can be controlled by raising the rear wheel and pressing
the push button (CAUTION – pedals begin to turn immediately – take care to avoid injury! – Do
not brake abruptly). There must always be a minimum of 15 rpm – below that the drive swit-
ches off automatically for safety reasons. The drive has an optimal support at a speed of min.
60 rpm. Disconnect the battery after each trip and take it with you into the house (especially at
sub-zero temperatures)! This is also a protection against unauthorized use.
short descriPtion
