Vivax CF-278 S, Руководство пользователя

Страница: 39 / 64

VIVAX
ENG
.
14
◆
During high ambient temperatures e. g. on hot summer days. It may be
necessary to set the thermostat to the Coolest setting (position “
Max ”). This
may cause the compressor running continuously in order to maintain a low
temperature in the cabinet.
◆
For the first time you install your refrigerator, set the thermostat knob at “ Med ”.
Give your refrigerator time to cool down completely before adding food. It is
the best to wait 24 hours before adding food. The thermostat knob controls the
temperature.
For the first time you install your refrigerator, set the thermostat knob at “ Med ”.
Give your refrigerator time to cool down completely before adding food. It is
the best to wait 24 hours before adding food. The thermostat knob controls the
temperature.
◆
When the Thermostat knob is turned up to the end position, below the
"Min" position, the Refrigerator will stop cooling
.
WARNING: When you set the higher temperature (position MIN or below),
in that case the compressor will not switch-on often or it will be turned
off some period of time, but this does not mean that the refrigerator is
disconnected from the power supply.
For cleaning and maintenance, be sure to disconnect the power supply
device by pulling the plug out of the socket!
Noise Inside the Unit!
You may notice that your unit makes some unusual noises. Most of these are
perfectly normal, but you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling
system. It has become more pronounced since the introduction of CFC free
gases. This is not a fault and will not affect the performance of your unit. This is
the compressor motor working, as it pumps the refrigerant around the system.
Change the Light Bulb
The LED lamp must be replaced by authorized service.
The first Start
Cleaning Before Use
Wipe the inside of the unit with a weak solution of
bicarbonate soda. Then rinse with warm water using a
'Wrung-out' sponge or cloth. Wash the shelves and salad
bin in warm soapy water and dry completely before
replacing in the unit.
Clean the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning
section