Page 35 of 44
™
4 Loc3 Series Transmitters
WARNING
Only use a charger supplied by Vivax-Metrotech Corp. Using non-approved chargers may damage the
equipment or overheating/explosion.
The rechargeable tray cannot be charged from a 12V DC source.
Follow instructions detailed in the General Safety & Care Information section of this manual. Only use the battery charger
supplied as using an unapproved charger may damage the battery pack and cause overheating.
4.4 Removing and Installing the Battery Tray
These procedures apply to both the Alkaline and Rechargeable battery tray.
Removing the battery tray
1. Reach under the catch and pull to
unlock.
2. Lift the catch and repeat for all four
catches.
3. Lift the transmitter base from the
battery tray.
Installing the battery tray
The battery tray and transmitter base
have a matching aligning post, contact
pins and socket.
Aligning the contact pins in their
receptacles will ensure that they will
mate and not get damaged.
1. Align the aligning post and lower
the transmitter base into the battery
tray.
2. Press down on the locking catch
until it clicks and locks in place.
Rotate the transmitter locking all the
latches.
4.5 Transmitting Modes
WARNING
Always connect the transmitter to the target line following your company's procedures. These
operations should only be performed by authorized personnel. Always make connections before
switching on the unit. Turn the transmitter off before disconnecting.
