Viva VVA62U150, Инструкции по монтажу

Страница: 12 / 28

12
Fitting the extractor hood
To the wall
With 3 screws.
1. Mark mounting boreholes.
Dimensions can be found in or use
template.
2. Drill 8 mm dia. holes and insert wall
plugs flush with the wall.
3. Screw in the upper screws (on left and
right) until there is a gap of approx.
7 mm between the screw head and the
wall.
7 mm
4. Remove the filter grille (see Instructions
for use)
5.
Attach the extractor hood.
6. Tighten the lower screw (with washer)
inside the extractor hood.
Fitting the extractor hood
To a wall-hanging cupboard
With 4 screws.
1. Dimensions for the mounting boreholes
can be found in, or place a template on
the base of the wallhanging cupboard.
2. Mark the mounting holes and make pilot
holes with a bradawl.
In exhaust-air mode (upwards) mark the
exhaust-air opening and saw out.
❑
Consider the location of the
connection cable; if required, saw out the
cupboard.
3.
Remove the filter grille (see Instructions
for use).
4. Screw the extractor hood to the base of
the cupboard.
g. 6
3
1
2
3
1
1
2
2
3