Vito Agro VIME7, Инструкция по эксплуатации

Страница: 45 / 72

45
Handlebar assembly
1. Place the handlebar (14) into the column upper
opening;
2. Place the knob and handlebar height regulator (20)
into the hole corresponding to the handlebar height.
3. Place the handle/nut knob in the handlebar grip;
4. Tighten the grip knob (20);
5. Place the upper handlebar protection (9), tighten the
three fixing screws;
Fenders assembly
1. Adjust the fenders (24) according to the holes for the
fixing screws;
2. Place the fixing screws with a washer, a rubber
damper and a clamping nut;
3. Place the fenders’ connecting plate;
Transmission belt cover assembly
1. Adjust the transmission belt cover (23) according to
the holes for the fixing screws;
2. Place the damping rubbers and tighten the fixing
screws;
Exhaust’s protection grid assembly
1. Place the protection grid (22);
2. Tighten the fixing screws;
Prefilter assembly
1. Place the air prefilter (10) in the handlebar grip, next
to the throttle adjusting knob (12);
2. Tighten the fixing clamps;
Blades assembly
Assembly
1. Insert the 4-blade set shaft into the set shaft with 2
sets of 4 blades;
2. Place and tighten the screw with washer and nut;
3. Place the disc shaft into the blade shaft with 1 set of
4 blades;
4. Place and tighten the screw with washer and nut;
All blades must be oriented in the same direction,
check the indications attached to the shafts with
the corresponding side of each blades set (R, L);
Placement on the traction shaft
5. Engage the blades’ shaft in the traction shaft,
according to the indication given (

);
6. Place the pin in the blade shaft’s inner hole and in
the traction shaft. Place the beta key.
The blades must have the cutting edges pointing
forward.
2.
1.
4.
3.
5.
Fixing
screws
Connecting plate
fixing screws
fenders’
connecting plate
5.
1.
2.
4.
3.
6.