OPERATING INSTRUCTIONS:
Before inserting the plug into an electrical outlet, make sure that the electrical supply in your
area matches that on the rating label on the unit.
When plugged in, turn on the Main power switch at the back of the unit.
When in Standby mode, only the switch
on both control panel and remote control will
respond to your touch, and the LED display shows the room temperature. Press
to access
the rest of the control panel or remote control
a)
Low Power: (Press “
” to switch it)
b)
High Power: (Press “
“to switch it)
c)
TIMER: Press ”
” button repeatedly to set a period after which the heater will turn
itself off (From 0 to 8 hours)
d)
+ , - : adjust room temperature .Temperature setting from 50-95°F degree. “+” to
increase the desired temperature and “-“ to decrease the desired temperature. (On
Remote control only)
e)
Osc : Press “
“to activate oscillation. Press it again to cancel.
f)
Press
to turn off the heater, the unit will keep working 30 seconds of cool air after turn
off it . this design can protect item use longer.
Warning: The heater will remain hot for some time after it is turned off; handle with care.
REMOTE CONTROL
The remote control uses on button cell battery, type CR2025(3V).To remove the battery carriage
use your thumb to squeeze the release tab to the right and then pull the carriage out. Place the
battery into the carriage and slide the carriage back into the remote. See Fig.1. We recommend the
use of a Lithium-ion battery for longer use.
NOTE:
Follow battery disposal instruction on battery
packaging, or contact your local safety council for safely disposal of batteries.
Before using the remote control, you must remove the insulating film as shown in the figure below.
1.
All functions performed with remote control work identically to the heater control panel.
2.
Aim the remote control at the heater control panel to operate the heater.
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance automatically in
case of overheat, e.g. due to the total or partial obstruction of the grids. In this case, unplug the
appliance, wait about 30 minutes for it to cool and remove the object which is obstructing the grids.
Then switch it back on as described above. The appliance should operate normally. Should the
problem persist, please contact the nearest customer service.
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance automatically when the
heater falls over, or is at an excessive angle from the horizontal. This helps prevent accidents, and
the heater will back to the standby mode when it is put back upright, press the buttons on control
panel or remote control to reset the heater
SPECIFICATION
Model No
KPT-5167HL
Voltage
120V AC
Frequency
60Hz
Output Power (W) 1500W
