Vitek VT-8556, Инструкция по эксплуатации

Страница: 5 / 28

5
ENGLISH
–
Remove the HEPA filters (8) from the pack-
aging material.
–
Insert the HEPA filters back into the tank.
–
Install the upper unit part (1) on the tank (4).
Warning! Before filling the tank with water,
switch the unit off and unplug it. Be careful not
to get the unit body wet.
Note: Use the unit at the room temperature
between +10°C and +40°C and the relative
humidity less than 80%. The used water tem-
perature should not be higher than +40°С.
USING THE AIR WASHER
–
Remove the upper unit part (1).
–
Remove the HEPA filters (8) from the tank (4).
Soak the filters in water.
–
Insert the soaked HEPA filters (8) back into
the tank (4).
Warning! The filters should be cleaned regu-
larly, at least once a week.
–
Fill the tank with water up to the maximum
level. Always use clean, cold tap water. Since
water quality varies by region, it is recom-
mended to use distilled or filtered water to
minimize the risk of contamination and calci-
fication (scale formation).
Warning! Do not exceed the maximum mark.
–
Install the body (1) on the tank (4). If you
spill water, before switching the unit on, dry
it and the surfaces where water has been
spilled, and make sure that all parts of the
unit and the surface, on which the unit is
placed, are dry.
–
Connect the unit to the mains.
–
Switch the unit on by pressing the on but-
ton (11).
–
When the unit is turned on, the built-in air ion-
izer is automatically activated.
–
Set the unit operating modes accord-
ing to your preferences. After pressing
the buttons (11), the LED indicator of the
selected operation speed (12) will light up,
to change the selected operation speed,
press the corresponding button again (the
programming function will be deactivated
after the successive switching of all three
modes).
Timer setting
By successively pressing the button (9) « »,
set the required timer operation time, while the
LED indicator (10) of the corresponding mode
will light up:
1Ч – corresponds to a 1-hour timer operation
2Ч – corresponds to a 2-hour timer operation
4Ч – corresponds to a 4-hour timer operation
Humidity level setting
By successively pressing the button (11) « »
set the required operation speed, the LED indica-
tor (12) of the corresponding speed will light up:
I – corresponds to low operation speed
II – corresponds to medium operation speed
III – corresponds to high operation speed.
–
After using switch the unit off with the button
(11) (the unit will be off after switching through
all three humidity levels – after the «III» mark
(intensive operation mode), the next press of
the button will switch the unit off).
–
Unplug the unit.
Note! This unit does not provide an auto-off
function, when there is no water in the tank.
Check for water in the tank periodically and top
it up if necessary.
CLEANING AND CARE
–
Switch off the unit and unplug it before clean-
ing.
–
Do not use polish, gasoline or other chemical
cleaners for cleaning.
–
Wipe the cleaner body with a soft, slightly
damp cloth, then wipe it dry.
–
Clean the air inlet and outlet air grids as they
become dirty.
–
Fill the tank with water and rinse. Fill the tank
with water and pour 2 tablespoons of vinegar
into it. Leave the water with vinegar for about
half an hour, then drain it and rinse the tank
under the running water. You can also use a
citric acid descaler to clean the tank.
Warning! Clean the water tank at least once a
week.
–
Wash the HEPA filters with cold running water
and let them dry naturally. When washing, you
can use a soft brush.
Warning! The HEPA filters should be cleaned
regularly, at least once a week.
Warning! Do not place the upper unit part under
a tap or submerge it partially in water. Leaving
the water in the tank for longer than a few days
can cause bacterial growth, so the water should
be replaced with fresh one every day.
STORAGE
–
Before storing the unit, drain the water tank,
remove the filters and let them dry naturally.
Wipe the cleaner body and the tank with a
soft, slightly damp cloth, then wipe them dry.
Make sure the tank and the body are dry.
–
Do not store the unit with water in the tank and
with wet filters.
–
Store the air cleaner in a dry cool place out of
reach of children and disabled persons.
IM VT-8556.indd 5 8/25/20 3:18 PM