Vitek VT-8490, Инструкция по эксплуатации, Страница: 5 / 44

5
ENGLISH
•
Do not use the coffee maker if the power cord
or the plug is damaged, if the unit malfunctions
or if there are other damages in the unit.
• If the power cord is damaged, it should be
replaced by the manufacturer, a maintenance
service or similar qualified personnel to avoid
danger.
•
Do not attempt to repair the unit. Do not dis-
assemble the unit by yourself, if any mal-
function is detected or after it was dropped,
unplug the unit and apply to any authorized
service center from the contact address list
given in the warranty certificate and on the
website www.vitek.ru.
•
Transport the unit in the original package only.
• Keep the unit out of reach of children and dis-
abled persons.
THIS UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY. ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES IS
PROHIBITED.
EFORE THE FIRST USE
After unit transportation or storage at low
temperature keep it for at least three hours at
room temperature before switching on.
Before using the unit
•
Make sure that the unit is switched off.
• Attention! Before using the coffee maker
for the first time remove the red rubber
plug from the water tank (16).
• Before using the coffee maker for the first time,
wash all removable parts with warm water and
dry them.
• Before switching the unit on, make sure that
the mains voltage corresponds to the voltage
specified on the unit body.
• Remove the water tank (16), fill it with cold
water till the MAX mark and install it back to its
place (pic. 1).
•
Remove the milk tank (11), fill it with cold water
till the MAX mark as well and install it back to its
place (pic. 2).
•
Select one of the coffee filters (20 or 21), and
insert it into the holder (19), matching the
ledge on the filter with the hole on the holder
(19) and turn the filter clockwise/anticlockwise
(pic. 3, 4).
•
Install the filter holder into the coffee maker.
Holder ledges (19) should match the groves on
the boiler (pic. 5) and then turn the filter holder
handle (17) to the right till bumping (pic. 6, 7).
• Place a corresponding cup on the respective
tray (3 or 5) and turn the cappuccinator pipe (2)
to the cup using the bar (8) (pic. 8).
• Insert the power plug into the mains
socket.
• Switch the coffee maker on by pressing the
button (14), the illumination of the buttons
(23, 24 and 25) on the control panel will start
flashing.
•
When the illumination stops flashing, press and
hold the espresso button (23) for 3 seconds.
Let the water run for 80-90 seconds.
• Press the button (23) once again to switch
water supply off.
•
Select the washing mode “Cleaning” by turning
the frothed milk supply knob (9).
•
Then press and hold the cappuccino button
(24) for 3 seconds. Let the water run for 80-90
seconds.
• Press the button (24) once again to switch
water supply off.
•
The illumination of control buttons will light up
constantly, that means that the unit is ready for
operation and the boiler is clean.
Attention!
•
Do not remove the filter holder (19) during the
unit operation.
•
Do not remove the filter holder (19) immediately
after preparing coffee as there is redundant
water and steam pressure inside, let the coffee
maker cool down completely.
• To remove the filter holder (19) turn the handle
to the left and remove the holder.
Choosing the appropriate cup
Drink Estimated
volume of the
ready product
Espresso One cup
Two cups 30-40 ml
70-80 ml
Cappuccino One cup
Two cups
170 ml
280 ml
Latte One cup
Two cups 340 ml
430 ml