Vitek VT-8234, Инструкция по эксплуатации

Страница: 6 / 36

6
ENGLISH
– After unit operation, switch the hairdryer off by set-
ting the switch (1) to the position «0», and unplug it.
Nozzle
Use the nozzle (3) when you need to focus the power
of drying on a small area (for example, a curl or a wave)
or when you want to straighten wavy hair.
–
Attach the nozzle (3) to the unit body. The nozzle (3)
allows directing a narrow air flow of high intensity at a
definite hair lock.
– Insert the power plug into the mains socket. Use the
switch (1) to set the necessary operation mode.
Overheating protection
Overheating protection switches the hairdryer off if the
outgoing air flow is too hot. If the hairdryer switches off
during operation, set the operation mode switch (1) to
the “0” position, unplug the hair dryer and make sure
that the inlets and outlets are unblocked. Let the hairdryer
cool down for 5-10 minutes and switch it on again. Do not
block the air inlets during unit operation and avoid getting
of hair into its air inlet.
CLEANING AND CARE
–
The hair dryer is intended for household use only.
– Set the switch (1) to the position «0» and disconnect
the hair dryer from the mains.
– You may wipe the unit body (2) with a damp cloth and
then wipe it dry.
– Clean the air inlet grid (4) with a brush.
– Never immerse the unit into water or other liquids.
– Do not use abrasives and solvents to clean the unit
body.
STORAGE
–
Unplug the hair dryer if you are not using it.
– Let the hair dryer cool down after its usage, keep the
unit away from children in a dry cool place.
– Never wind the power cord around the hairdryer, as
this can damage the cord. Handle the power cord with
care, do not pull, twist or stretch it, especially near
IM VT-8234_70x130.indd 6 11.04.2019 14:23:12