Vitek VT-6603 BK, Инструкция по эксплуатации

Страница: 7 / 48

7
ENGLISH
« ALM1/VOL + » to set the first alarm. Blinking alarm time
digits and the selected alarm indicator (10) or (12) will
appear on the display.
• Consequently press or hold the button (2)
«
9
/HR»
,
to set the alarm time in hours.
•
Consequently press or hold the button (3) «
:
/MIN»
to set the alarm time in minutes.
•
To finish the setup procedure, press the button (5)
«
ALM2/VOL– » or (6) « ALM1/VOL + » respectively.
•
Select the necessary alarm signal: sound signal
(«
Buzzer » symbol) or radio switch on (« Radio » symbol).
To do it, consequently press the button (5) « ALM2/VOL – »
or (6) « ALM1/VOL + » in the current time mode.
Depending on your choice the corresponding indicator
will light up:
– the indicator (10) shows that the second alarm sound
signal is selected as an alarm signal;
– the indicator (11) shows that the radio is selected as the
second alarm signal;
– the indicator (12) shows that the first alarm sound signal
is selected as an alarm signal;
– the indicator (13) shows that the radio is selected as the
first alarm signal;
Notes:
– If you want to select the radio as an alarm signal,
preliminarily tune the required radio station (see
«Radio stations reception»).
– The alarm actuation is possible only when the unit is
connected to the mains.
– At the alarm actuation the volume level increases
gradually from minimal to maximal value within
10 seconds.
– If the button (2) « 9 /HR» or (3) « : /MIN» is not
pressed within 20 seconds during the setup proce-
dure, the unit will be switched back to the current
time mode.
Switching the alarm on/off
•
To switch the alarm (alarms) off in the current time mode
consequently press the button (5)
«ALM2/VOL–» or (6)
«ALM1/VOL +» , until the corresponding alarm indica-
tors go out.
•
To switch the alarm (alarms) on in the current time
mode consequently press the button (5)
«ALM2/VOL –»
VT-6603_IM_70x130.indd 7 27.10.2017 10:24:29