Vitek VT-6603 BK, Инструкция по эксплуатации

Страница: 6 / 48

6
ENGLISH
and programmed radio stations in case of power failure.
Once the mains voltage is restored, the unit is switched
to the mains power supply.
Note: The alarm sound signal will be on only if there is
power in the mains.
•
Open the battery compartment lid (14). Insert 2 AAA bat-
teries (not supplied), following the polarity.
•
Close the battery compartment lid (14).
•
To connect the unit to the mains, insert the plug of the
power cord into the mains socket.
Attention!
Batteries leakage can cause injuries or unit damage.
To avoid damages, follow the recommendations specified
below:
– insert batteries following the polarity;
– remove the batteries if you are not planning to use the
unit for a long time.
– do not dismantle the batteries; do not subject them to
high temperatures;
– replace the batteries in time.
TIME SETTING
•
Plug the unit into the mains
•
Press and hold the button (1) « CLK/MEM », blinking
time indications will appear on the display.
•
Consequently press or hold the button (2) «
9
/HR» ,
to set the necessary hour.
•
Consequently press or hold the button (3) « : /MIN»
to set the minutes.
•
To finish the setup procedure, press the button (1)
«
CLK/MEM ».
Note: If the buttons (2) « 9 /HR» or (3) « : /MIN» are not
pressed within 20 seconds during the setup process,
the unit will be switched to the current time mode
.
Alarm setting
•
To view the alarm time, press the button and hold the but-
ton (5) «
ALM2 /VOL– » or the button (6) « ALM1/VOL + »
respectively. The alarm time will appear on the display. If
no buttons are pressed within 20 seconds, the unit will
be switched to the current time mode
•
In the current time mode press and hold the button (5)
«
ALM2/VOL– » to set the second alarm or the button (6)
VT-6603_IM_70x130.indd 6 27.10.2017 10:24:29