Vitek vt-3454 bk, Инструкция по эксплуатации

Страница: 5 / 44

ENGLISH
5
and damages of the unit. To avoid damages of
batteries follow the instructions below:
- Place the batteries properly, following the po-
larity;
- take the batteries out if you are not going to
use the unit for a long time;
- do not recharge the batteries, do not disman-
tle them, and do not subject them to high tem-
perature;
- replace the batteries in time.
Connection of the headphones
To listen to the music via earphones (not sup-
plied) connect them to the PHONES JACK. When
connecting the headphones, the speakers will
switch off automatically.
Attention! Do not use high volume while using
the headphones. Doctors do not recommend
continuous using of headphones.
AUX IN function
To connect an external device, use the AUX IN
jack. Connect the external device using the au-
dio cable 3,5 mm Jack - 3,5 mm Jack (not sup-
plied).
BASIC FUNCTIONS
Volume control
Use the volume control to select the desired vol-
ume level.
Radio stations reception
1. Set the FUNCTION switch to the RADIO posi-
tion.
2. Select the desired band: FM ST or MW, by
setting the BAND switch to the corresponding
position.
3. Rotate the TUNING knob to select the desired
radio station.
4. After you finish listening to the radio set the
FUNCTION switch to the OFF position.
Antenna
For better reception in the FM band, extend the
antenna completely and position it at the desired
angle.
Playback of CD discs
Note:
Loading – Open the disc slot. Insert a CD disc
and close the lid.
Ejecting – After the playback is stopped, open
the disc slot lid and remove the disc. Put the disc
in the case.
Always close the disc slot lid to prevent dust from
getting into the disc slot. Always remove the disc
from the disc slot if it is not being played back.
1. Switch on the unit.
2. Select the CD discs playback mode. To do it
set the FUNCTION switch to the CD position.
3. If there is no a disc in the disc slot or if the disc
is damaged the “no” symbols will appear on
the LCD-display.
4. Open the disc slot. Insert a disc and close the
disc slot lid. Make sure that the disc is insert-
ed properly – with the label upwards.
5. The number of tracks and the “CD” symbols
will appear on the LCD-display.
Note: The unit supports playback of CD-R and
CD-RW discs
Playback
In the stop mode press the PLAY/PAUSE
button, the playback of the disc will start.
3454IM.indd 5 3454IM.indd 5 15.09.2010 16:33:18 15.09.2010 16:33:18