Vitek VT-2569, Инструкция по эксплуатации

Страница: 9 / 52

9
ENGLISH
Step 5 – the final part
–
In the final stage of hair cutting remove the attach-
ment comb from the unit, turn the blades of the clip-
per towards the hair and trim hair on the temples
and neck carefully. Do not press the clipper strongly,
there is danger of injuries or cuts when open blades
come in contact with skin (pic. 9).
Cone-shaped haircut
Set the necessary attachment comb and start cutting
from the head back towards the crown. Cut hair against
hair growth from the head front to the crown and from
the sides (pic. 10). To get a flat top haircut, use the
comb: lift the locks and cut them along the comb. Comb
the hair to reveal uneven locks.
After you finish cutting hair, switch the hair clipper off
setting the power switch (1) to the position «0» and
take the power cord (5) plug out of the socket, put the
protective cover (10) on the blades.
CLEANING AND MAINTENANCE
Lubricating the blades
Regularly lubricate the blade with oil.
–
Switch the hair clipper off using the power switch (1)
and disconnect the power cord (5) plug from the
mains socket.
– Apply one-two drops of oil on the teeth of the
blades (3, 4) and the back side of the upper blade (3),
switch the unit on and make sure that the blades are
moving smoothly.
– Switch the unit off, clean the excess oil with a dry cloth.
Attention! Use only liquid oil, for instance, petroleum jelly.
DO NOT USE vegetable oil, fat, oil mixed with any sol-
vents for lubricating. Solvents will evaporate, leaving
thick grease that may slow down the blades’ motion.
Cleaning the hair clipper
–
Switch the hair clipper off and unplug it.
– Clean the blades from hair, using the cleaning brush (12).
– Wipe the accessories and the unit body with a slight-
ly wet cloth, and then dry them with a soft cloth.
IM VT-2569_70x130.indd 9 24.12.2018 12:23:14