Vitek VT-2569, Инструкция по эксплуатации

Страница: 6 / 52

6
ENGLISH
Blades
–
If the blades have been removed for cleaning or
replacement, install them back, adjust and tighten
the fastening screws (pic. 1).
Blade shifter (2) (pic. 2)
–
When you cut hair without using attachments (6, 7, 8, 9),
you can shift the blade to adjust the cutting length.
–
In the upper shifter (2) position, haircut will be the
shortest.
– In the lower shifter (2) position, the cutting length is
approximately the same as when using 3 mm attach-
ment comb (6).
– By changing the position of the shifter (2) while
cutting hair, you can select the necessary cutting
length.
–
If hair is jammed in the blades while cutting, move
the shifter (2) from the upper to the lower position or
vice versa several times, this will help to release the
jammed hair without removing the blades.
– When the hair clipper is switched on, move the
shifter (2) several times from the upper to the lower
position or vice versa, in this way you can remove the
cut-off hair from the blades.
–
If the hair clipper pulls hair while cutting, it means
that the blades became blunt, replace them with
new ones.
Lubricating oil
–
To maintain the unit in a good condition, you should
lubricate the blades periodically. Do not use vegeta-
ble oil or oil that includes solvents. Solvents are sub-
jected to evaporation, and the remaining thick oil can
slow down the upper blade moving speed.
– It is recommended to use liquid oil for lubricating the
blades, such as petroleum jelly.
HAIR STYLING INSTRUCTIONS
•
Hair should be clean and dry during hair cutting.
•
Insert the power cord (5) plug into the mains socket.
IM VT-2569_70x130.indd 6 24.12.2018 12:23:14