17
4. Power ON and OFF
4.1. Instruction
Please double check the Precautions for use in section 1.3.
4.1.1 System Power ON
n
Installation (including DC cable, communication wire connection and dialer switch) is properly do
ne
.
n
Press Power Switch button, green LED should be twinkling and then turn into function mode. (system
status can be red from LED signal, as shown below)
4.1.2. System Power OFF
Attention: It must be confirmed that the system is off before taking off DC cables.
Press Power Switch button
Green LED should be twinkling and then turn into stop mode
4.1.3. Sleep and Wake-up Function
Number
Sleep Condition
Wake-up Condition
Mark
1
Forced sleep by upper computer
Reset button
2
Forced sleep by soft switch
Soft switch
Only those equipped with
soft switch can pass the
call Wake up
3
Total Voltage is lower than 48V
or monomer is lower than 2.8V,
and continuous No charge and
discharge current for 4 hours,
no communication goes to
sleep
Reset button
Soft switch
Communication
Charging
Only those equipped with
soft switch can pass the
call Wake up
4.1.4. Buzzer Function
n
0.25s per 1s in case of fault
n
0.25s per 2s during protection
4.1.5. System Status Instruction
There are 6 LED indicator, 4 green LED gives status of SoC, 1 red Alarm LED and 1 green Running
Status LED (indicating charging, discharging etc.)
Website: www.
vitechpower.com.au
