IMPORTANT: DO NOT BREAK OR REMOVE THE SEAL FROM AROUND THE NECK OF THE WATER BOTTLE,
(See Fig. 5) OTHERWISE YOU WILL NOT BE ABLE TO LIFT/CARRY THE WATER BOTTLE WITH THE CARRY
HANDLE. (See Fig. 6)
5. To install the water bottle inside the bottle storage compartment, simply position the bottle in front of storage
compartment ramp and (push) slide inside using the side of your leg until the bottle comes to a stop.
6. Close the lower compartment door and the water pump will start delivering water into the dispenser automatically.
When the internal reservoirs are full, the water pump will stop automatically.
IMPORTANT NOTE: Your Vitapur® water dispenser is designed with a special "safety" feature (float switch
mechanism) that controls activation/operation of the Kettle Feature hot water tank heating system. If no water is
present and/or low water levels are detected inside the internal water reservoir, activation/operation of the
Kettle Feature hot water heating system is not possible. Likewise, if the hot water heating system is operational
and water is being drawn simultaneously causing internal water levels to drop below the established minimal
level set point, hot water tank operation is automatically suspended. To reactivate the hot water heating system,
you must replenish your water supply.
NOTE: The water pump system also incorporates a special safety feature that prevents/stops operation in the absence
of water. (i.e. empty water bottle conditions) Water pump operation is also linked to a door switch system mounted inside
the lower storage compartment.
i.e. Door open = pump operation suspended.
Door closed = normal pump operation.
Dispensing Room and Cold Water
Place a glass under the dispensing spigot on the right side of the water outlet panel. For cold water, press/hold
dispensing button (#7) until the desired amount of water is dispensed and release. For room temperature water,
press/hold dispensing button (#6) until the desired amount of water is dispensed and release.
4
FIG. 1. 11.4L (3gal) bottle
FIG. 5. Water bottle seal in tact
CORRECT
INCORRECT
FIG. 6. Water bottle seal removed
FIG. 2. 18.9L (5gal) bottle
FIG. 3. Handle Open
FIG. 4. Handle Closed
