Vitalograph VitaloJAK 7100, Инструкция по эксплуатации

Страница: 6 / 36

ENG
6 Page of 36 DT_0006 Issue 15
A Global Leader in Respiratory Solutions
To get the VitaloJAK ready for use:
• Check that the contents of the packaging correlate with the site
and test kit contents specified in the site manual.
• Check the serial numbers of the VitaloJAK, Site Kit and Test Kits
against the packing list in your shipment. Serial numbers should
match.
• Please read, retain and refer to all study material, product
information and instruction manuals that are sent to you.
2.1. Connecting the VitaloJAK to a PC
1. Follow the site manual instructions to access the
Webportal.
2. If the device is powered on, use the key to turn it off prior
to connecting it to the PC. The red dot on the keyswitch
should line up with the ‘O’ mark on the case when the
device is powered off.
3. Unscrew the back cover of the device using screwdriver
provided. Remove the back cover.
4. If the device has previously been used, remove the
microphone and chest sensor wire and battery, following
instructions at Section 3.4 and 3.5. Before setting up the
VitaloJAK for a different subject, clean the device according
to cleaning and hygiene instructions at Section 4.
Note: The data cable, chest sensor/air microphone and battery
pack connectors have a locking mechanism to stop accidental
disconnection or damage.
5. For studies using a removable SD card instead of the
internal flash memory, an SD card should be inserted at
this stage using SD Card Tool provided.
6. Connect one end of the data cable to the device via the
cable connector (Figure 2) and the other to the PC used
to access the Webportal. The battery should be detached
when the VitaloJAK is connected to the web portal.
7. Follow the instructions on the Webportal.
Note: Do not configure the device for a subject until a recording is
due to take place.