PAGE 15
G. FREEZE PROTECTION
If the temperature in the spa plumbing falls
below 50º Fahrenheit (10º Celsius) the
water pump(s) will turn on soft-mode and
run for at least one minute. The display will
show
“ICE”
. After one minute, if the water is
still below 50º F (10º Celsius), the heater
will turn on and raise the water temperature
10º F.
H. FLOW PROTECTION
If the flow of water through the heater
is insufficient, the spa controller will
automatically turn the heater off to
prevent overheating. The display will show
“FLO”
, indicating a flow restriction caused
by a clogged filter, shut gate valves or by
a malfunction in the pressure switch. Call for
service if you cannot pinpoint the cause.
I. OVERHEAT PROTECTION
If the water temperature inside the spa
reaches 110º F, the display will show
“HILI”
(High Limit) and the heater will be disabled.
If the water temperature continues to rise
and reaches 118º F due to friction in the
pumps and plumbing system, the entire
system including all pumps will be disabled.
In
“HILI”
condition,
DO NOT ENTER THE
WATER!
Remove the cover and allow the
water temperature to cool down to 104
degrees F. Then reset the system by holding
down the
“PROG”
button for 5 seconds. If
the
“HILI”
message returns, call for service.
K. H.E.E.T. PUMP
Each spa is equipped with Vita Spa’s
exclusive
High Efficiency Energy Transfer
pump. Similar to the principle of heat
transfer pumps, the
H . E . E . T.
s y s t e m
transfers the heat generated by the
circulation pump motor to the water 24
hours a day. After the first twelve hours of
operation each day, as a protection against
overheating, the
H.E.E.T
. pump will turn off
if the water temperature exceeds the
desired temperature. The 4kw-system
heater will come back on when the water
temperature falls 1 degree F° under the
desired temperature.
L. SKIM–AWAY
S k i m – Away is an automatic skimming
action which takes place each day from
8am until 8:30am each morning and
from 4pm until 4:30pm each afternoon.
The primary pump will activate in high
speed mode. This will pull all surface oils
and debris into the filter well cavity.
M. REMOTE CONTROL
Your spa model may come equipped with a
remote control located on the opposite side
of the spa from the main spa side control.
The remote control will operate the jets,
blower, and light. It can not be used to
program the spa.
