Gasket Installation Instructions:
1. Follow the instructions on page 12 for preparing the counter area for the installation of
your In-Counter Blending Station.
®
Also, use the Template Sheet (provided in your
machine’s original package) to assist you in the placement and ventilation of your machine.
2. Unplug the machine. Lay the machine on its back with the motor pointing toward you.
Allow 1-2 in. / 3-5 cm of the motor base to hang over the edge of the counter top to
facilitate easy fitting of the gasket.
3. Slide the power cord through the gasket, with the groove of the gasket pointing toward
the machine base.
4. Starting at one corner of the motor base, press the gasket onto the motor base so that the
groove in the gasket seats itself onto the stepped bottom edge of the motor base (see
Figure B).
5. Working around the bottom edge of the motor base, press the gasket onto the motor base
until the entire perimeter of the gasket is firmly attached to the motor base.
6. Carefully place the machine into the hole in the counter.
7. Be sure that the gasket is properly seated on the motor base and against the counter top.
Front
Back
WARNINGS!
This gasket was designed to protect your machine from water damage and to reduce noise. Failure
to properly install this gasket could result in moisture damage.
Do not
secure the machine to the
counter with bonding materials.
FIGURE A
FIGURE B
14
